If you setting hex values correct format is:
snmpset($source_ip,$community,"$oid","x","10 10 10 10");
snmpset
(PHP 4, PHP 5, PHP 7, PHP 8)
snmpset — Valorizza un oggetto SNMP
Descrizione
snmpset(
string
string
string
string
mixed
int
int
): bool
string
$hostname,string
$community,string
$object_id,string
$type,mixed
$value,int
$timeout = ?,int
$retries = ?): bool
Setta il valore di un specifico oggetto SNMP. La funzione restituisce true
se ha successo, false se si verifica un errore.
La funzione snmpset() viene usata per
settare il valore dell'oggetto SNMP indicato dal parametro
object_id. L'agente SNMP viene indicato nel parametro
hostname e la comunità viene specificata
nel parametro community.
add a note
User Contributed Notes 4 notes
deivis dot jakstas at gmail dot com ¶
17 years ago
slawrance at technologist dot com ¶
25 years ago
The "type" parameter must be one of the following, depending on the type of variable to set on the SNMP host:
i INTEGER
u unsigned INTEGER
t TIMETICKS
a IPADDRESS
o OBJID
s STRING
x HEX STRING
d DECIMAL STRING
n NULLOBJ
b BITS
If OPAQUE_SPECIAL_TYPES was defined while compiling the SNMP library, the
following are also valid:
U unsigned int64
I signed int64
F float
D double
As an example, using "i" would set an integer, and "s" would set a string. If the SNMP host rejects the data type, you might get the following message: "Warning: Error in packet. Reason: (badValue) The value given has the wrong type or length."
If you specify an unknown or invalid OID, you might get a "Could not add variable" message. When specifying an absolute OID (one that is already resolved) that is completely numeric, prepend it with a period. For example, an OID that could enable/disable Ethernet ports on an Asante hub might be "1.3.6.1.2.1.22.1.3.1.1.3.6.4.0", but you would need to use ".1.3.6.1.2.1.22.1.3.1.1.3.6.4.0" in the OID parameter so that the SNMP library won't try to resolve an already resolved OID. Friendly, unresolved OIDs do not need the period prepended, such as "system.SysContact.0"
ch at lathspell dot de ¶
14 years ago
Note that there are two ways to set a variable of the type BITS like e.g.:
SYNTAX BITS {telnet(0), ftp(1), http(2), icmp(3), snmp(4), ssh(5), https(6)}
1. Using type "b" and a list of bit numbers like:
snmpset('FOO-MIB::bar.42', 'b', '0 1 2 3 4');
with the disadvantage that the success is not easily verifyable as an snmpget() for the same OID would return e.g. 0xF8.
2. Using type "x" and a hex number but without(!) the usual "0x" prefix:
snmpset('FOO-MIB::bar.42', 'x', 'F0');
tridman ¶
17 years ago
If you have importet the MIB-Files into the MIB Tree with "snmp_read_mib" you may use '=' as the "type" parameter.
In this case the type will also be taken from the loaded mib file. (Octest strings will be interpreted like strings though)
Comes in handy for a more dynamic use of snmpset.
