I have just managed to modify this script to work with the Twitter API...
The changes are...
$req_url = 'https://api.twitter.com/oauth/request_token';
$authurl = 'https://api.twitter.com/oauth/authorize';
$acc_url = 'https://api.twitter.com/oauth/access_token';
$api_url = 'https://api.twitter.com/1.1/account';
$conskey = 'YOURAPPconskey';
$conssec = 'YOURAPPconssec';
And change
#$oauth->fetch("$api_url/user.json");
# verify_credentials
# TO
$oauth->fetch("$api_url/verify_credentials.json");
FireEagle
<?php
$req_url = 'https://fireeagle.yahooapis.com/oauth/request_token';
$authurl = 'https://fireeagle.yahoo.net/oauth/authorize';
$acc_url = 'https://fireeagle.yahooapis.com/oauth/access_token';
$api_url = 'https://fireeagle.yahooapis.com/api/0.1';
$conskey = 'your_consumer_key';
$conssec = 'your_consumer_secret';
session_start();
// При state=1 следующий запрос должен включать oauth_token.
// Если не включает, то возвращаемся к 0
if(!isset($_GET['oauth_token']) && $_SESSION['state']==1) $_SESSION['state'] = 0;
try {
$oauth = new OAuth($conskey,$conssec,OAUTH_SIG_METHOD_HMACSHA1,OAUTH_AUTH_TYPE_URI);
$oauth->enableDebug();
if(!isset($_GET['oauth_token']) && !$_SESSION['state']) {
$request_token_info = $oauth->getRequestToken($req_url);
$_SESSION['secret'] = $request_token_info['oauth_token_secret'];
$_SESSION['state'] = 1;
header('Location: '.$authurl.'?oauth_token='.$request_token_info['oauth_token']);
exit;
} else if($_SESSION['state']==1) {
$oauth->setToken($_GET['oauth_token'],$_SESSION['secret']);
$access_token_info = $oauth->getAccessToken($acc_url);
$_SESSION['state'] = 2;
$_SESSION['token'] = $access_token_info['oauth_token'];
$_SESSION['secret'] = $access_token_info['oauth_token_secret'];
}
$oauth->setToken($_SESSION['token'],$_SESSION['secret']);
$oauth->fetch("$api_url/user.json");
$json = json_decode($oauth->getLastResponse());
print_r($json);
} catch(OAuthException $E) {
print_r($E);
}
?>
add a note
User Contributed Notes 3 notes
brianmoreau at uk2 dot net ¶
11 years ago
pierre dot mihawk at gmail dot com ¶
10 years ago
In the case you're asking an API which gives you a reusable application key, you'll have to use the "verifier" in the getAccessToken() method, but also the "callback" parameter in the getRequestToken().
<?php
$request_token_info = $oauth->getRequestToken($req_url, "<YOU_CALLBACK_URI>");
?>
In my case, once I accepted the form in the Authorize URI, I was redirected to this callback URI with a "oauth_verifier" GET parameter. I injected it into the access token request :
<?php
$access_token_info = $oauth->getAccessToken($acc_url, '', $_GET['oauth_verifier']);
?>
I finally obtained an access token that I hardcoded ; it doesn't need any refresh.
